







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Trusted Fence Installation for Arlington Homeowners
Arlington sits on expansive Blackland and sandy loam soils that swell after rain and shrink in August heat, and that soil movement is the single biggest reason fences here lean, sag, and pull posts out of the ground years before the wood itself fails. We install fences built for that ground: posts set below the frost line into concrete, fastened with corrosion-resistant hardware, and lined up with your property survey instead of a best guess. Our technicians have up to 19 years of experience, and we bring that background-checked, uniformed crew to every job. Every visit also comes with a documented photo record of what we found and what we did, included as standard. Call (844) 761-7521.

What Our Fence Installation Service Includes

Fence work looks simple from the curb, but most failures start underground or at the fasteners. Under Clause 1 of the Haven Standard, you get a written flat price and written scope before anyone starts digging. Here are the fence types we install across Arlington.
Wood Fence Installation
Wood fencing remains the standard for Arlington backyards because it holds a stain well and handles the local humidity slightly better than untreated steel. You need a wood fence when you want classic privacy, a look that matches older Arlington homes, or a budget-friendly rebuild on a standard lot. We set cedar or pressure-treated pine posts in concrete, space stringers to code, and build gates that clear the ground so they don’t drag in the rain. Under the 365-Day Done Right Promise, if a panel heaves or a gate sags within the year, we make it right.
Chain Link Fence Installation
Chain link is the honest workhorse for side yards, pet runs, and commercial perimeters where privacy isn’t the goal. You need it when you want durable containment at the lowest cost per linear foot. We install galvanized or vinyl-coated chain link with properly tensioned top rails and brace bands, and we set terminal posts in concrete so corners don’t lean. For homes near Arlington’s commercial corridors, a shorter chain link with a privacy slat insert is often the right middle ground.
Vinyl Fence Installation
Vinyl fence is a good fit for homeowners who want a clean, painted look without annual sealing. You need it when you’re tired of restaining wood and want low upkeep on a new-construction lot. We install vinyl panels with steel or aluminum inserts in the rails so the fence stays straight through North Texas temperature swings, and we snap panels into routed posts rather than nailing them. Vinyl thickness matters, so we spec the heavy-wall profiles that hold up in Arlington heat.
Aluminum Fence Installation
Aluminum fencing gives you a metal look with less weight and no rust, which suits front yards and pool enclosures. You need it when you want visibility and security without the heaviness of iron. We install powder-coated aluminum panels with welded pickets and set posts into concrete footings. Because aluminum is lighter, gate frames need extra bracing, and we add a welded frame or heavy corner bracket so gates don’t warp over time.
Iron Fence Installation
Wrought or ornamental iron is the long-life option for premium frontages and estate-style lots. You need it when you want a fence that outlasts the house’s paint schedule and holds a security line. We install iron sections with concrete footings, rust-inhibiting primer, and proper spacing so gates swing true. Given iron’s weight, we anchor gates into reinforced posts rather than relying on the panel alone.
Fence Repair
Not every fence needs replacement, and we tell you plainly when repair is the better spend. You need repair when a section has heaved, a gate drags, or a few posts have rotted but the rest is sound. We replace posts, reset sagging panels, and re-hang gates with new hinges and latches – and our photo record shows exactly what was failing and what we corrected. If the substrate under a whole run is shot, we’ll show you the evidence and quote a replacement, not a patch that fails again in a year.
Privacy Fence Installation
A privacy fence is about screening, not just boundaries, and height rules vary by city and by lot. We install full-height privacy runs with tight board placement so gaps don’t show through, and we check Arlington’s height limits before we build. If you back onto a busy street or share a lot line with a two-story neighbor, we’ll suggest the right height and material so the fence does the job you bought it for.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Brands We Service for Fence Installation
We work with the material brands that hold up to North Texas weather, and we can service the same systems when they’re already in place. If your fence uses Sterling hardware, we know which components sit in the path of ground moisture and where they typically wear first. For fences built around Toto and Grohe fixtures at poolside or outdoor kitchen areas, the water line and hardware connections are what need the closest attention when a fence run abuts them.
Whether your fence is a classic cedar run, a welded aluminum panel system, or a commercial-grade run using Schluter trim details at the pool enclosure, whether you have Sterling, Toto, or any other make, we can help. We service the material systems and hardware lines we install, and we can inspect and quote what we find before a signed change order authorizes any extra work.
Signs You Need Fence Installation Right Now
- Posts that lean or wobble when you push them. A leaning post usually means the footing has failed or the ground has shifted, and the whole run is under load. Left alone, gravity pulls the panels down with it.
- Rotted or crumbling wood at ground level. Look at the bottom of each post and the base of the lowest rail. Soft wood at the base means moisture is winning, and that section can fail without warning in the next wind event.
- Gates that drag or won’t latch. A dragging gate is a hinge or footing problem, not a gate problem. Re-hanging saves the gate frame, but if the post is failing, you need a new post and footing.
- Visible gaps or loose pickets. Shrinking wood and loosened fasteners create gaps that undermine privacy and make the fence easy to climb. If you can wiggle a picket, the fasteners have backed out or the wood has shrunk around them.
- Rust, peeling paint, or holes in metal panels. Metal that has rusted through at a hinge or post base has reached the end of its service life in that spot. A spot failure often means the coating system has failed on the rest of the run too.
Our Fence Installation Process – Step by Step
- 1
Walk the line and document what’s there. We measure the run, check the existing posts and footings, and photograph the ground conditions, including drainage patterns and the location of any buried utilities. Nothing starts until you have the written scope and flat price in hand.
- 2
Confirm the layout and property line. We line the new fence up against the survey markers and adjust for setbacks and city height limits before we mark the hole locations. This step catches a bad layout before a single post hole is dug.
- 3
Set the posts and let the footings cure. We dig to the proper depth, set posts with concrete footings, and brace them plumb while they cure. Rushing this step is why so many Arlington fences lean within two years.
- 4
Frame, panel, and hang the gates. We install rails, fasten panels with corrosion-resistant hardware, and hang gates with proper clearance so they swing free. The crew photographs each completed section as part of the documented photo record.
- 5
Final walk-through and written record. We walk the finished fence with you, show you the photo record, and hand over the written warranty. If a change was needed mid-job, it was quoted and signed before we touched it.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Fence Installation Cost in Arlington?
Installing a fence in Arlington typically runs $3,500 to $9,000 for a standard residential run, depending on material, linear footage, and site conditions. A typical vinyl fence installation in Arlington runs $3,500 – $9,000 for a normal backyard, while aluminum runs $4,000 – $10,000 because of the heavier posts and welded frames. Wood privacy fencing sits on the lower end of the range, with cost rising for cedar, taller runs, and gates. Iron runs higher for the same linear footage given the material and labor.

What moves the number: total linear feet, material, gate count, terrain (slopes and old concrete add labor), and whether we’re removing an old fence. Texas limestone and clay soils can demand deeper footings in spots, which affects post count and concrete cost. To avoid overpaying, get a written line-item scope that separates material, labor, gates, and removal, then compare that line by line rather than on the bottom number. We also offer a free second opinion on any written estimate you bring us.
Your free estimate from us is flat, in writing, and includes material, gates, and cleanup. And if the scope changes once we’re on site, no work proceeds until the change order is signed. Call (844) 761-7521 to schedule.
Fence Installation Near Arlington – Our Service Area
We install fences across Arlington and the surrounding metro, including Grand Prairie, Mansfield, Euless, Cedar Hill, Duncanville, Irving, Grapevine, DeSoto, Glenn Heights, Coppell, and Highland Park. Typical response times for an estimate run within a few business days, with scheduling set around the weather window for your fence type. If you’re just outside Arlington, we’ll confirm coverage when you call. You can also see our work on neighboring pages like Fence Installation in Grand Prairie and Fence Installation in Mansfield.
Serving Arlington, TX – Our Local Coverage Area
We serve Arlington and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Fence Installation in Arlington

Fence installation is the process of setting posts, framing rails, and fitting panels to create a property boundary or privacy screen. It includes layout and property-line checks, post footings, material selection, and gate hanging. Every install we do in Arlington starts with a written flat price and written scope, so you know exactly what’s included before work begins.
A typical Arlington backyard fence takes one to three days of on-site work, depending on footage, material, and weather. Vinyl and wood installs tend to run faster than iron, which requires more welding and anchoring time. Concrete footings need cure time, and we factor that into the schedule so the finished run stays plumb. We’ll give you a realistic timeline in the written scope.
Fence installation in Arlington typically costs $3,500 to $9,000 for a standard residential run, with vinyl at $3,500 – $9,000 and aluminum at $4,000 – $10,000. Material, linear footage, gate count, and removal of an old fence are the main variables. Call (844) 761-7521 for an exact written quote – estimates are free.
Yes. We service the material systems and hardware lines we install, including the runs that use Sterling hardware and the poolside enclosures that incorporate Toto and Grohe fixtures near the fence line. Whether your fence is cedar, vinyl, aluminum, or iron, we can inspect and quote what we find before any change order is authorized. Call (844) 761-7521 to confirm your brand.
We answer calls with a live person around the clock, and we can respond to a fence down after a storm or a broken gate that leaves a yard open. Same-day response is not something we promise for planned installs, but we’ll tell you honestly what’s possible when you call. For urgent situations, (844) 761-7521 reaches a person, not a voicemail.
Every install is backed by our written warranty, and if something isn’t done right within the first year, the 365-Day Done Right Promise means we come back and make it right. The warranty is printed on your paperwork, not tucked in an asterisk. We also keep a documented photo record of the work as part of the job.
Clear the fence line of furniture, plants, and anything fragile, and make sure we can reach the gate with material. Move pets inside and confirm the property-line layout if you share a lot boundary with a neighbor. Remove any old fence panels you want hauled away, or tell us in the quote so removal is included – that keeps the price honest.
Schedule Your Fence Installation Service in Arlington Today
Whether you’re replacing a storm-damaged run, screening a busy street, or fencing a new yard, you’ll get a flat written price before anyone starts and a crew that leaves a documented record behind. Fencing is one of seven trades we cover, alongside Driveway and Pavers for the matching front path and Home Additions and ADU work if your yard plan is part of a bigger build. Call (844) 761-7521 for your free, no-obligation estimate and take the first step toward a fence that holds its line in Arlington soil.
Written by the team at Rowan Construction Group.












